Solenoid Contact Point Assembly Removal - Jeep 1987 Wrangler Workshop Manual

ELECTRICAL
STARTING SYSTEM - MOTORCRAFT (6-Cyl. Engine)
Solenoid Contact Point Assembly Removal
Remove the armature and brush holder before
starting this procedure.
CAUTION: Do not cut the field winding terminal
strap (2).
Cut the upper contact (6) as close as possible to
trie contact-point-to-field winding joint.
Unsolder the hold-in coil winding terminal wire
from the terminal strip.
Remove the field winding screws with an arbor
press and J-22516.
Remove the pole shoes.
Cut the rivets inside the frame with a chisel.
Remove the contact point assembly.
1 HOLD-IN COIL TERMINAL
2 FIELD WINDING STRAP TERMINAL
3 HOLD-IN COIL WIRE
4. LOWER CONTACT
5 COPPER RIVET
6 UPPER CONTACT
7. ALUMINUM RIVET
8 FIBER WASHER
9 SHOULDER
10 PLASTIC INSULATOR
84940
C-45