ELECTRICAL
STARTING SYSTEM - BOSCH (4-Cyl. Engine)
S E E
I.S.
N
O
T
E
S
Solenoid Switch Renewal
Remove terminal 45 on the solenoid.
Remove the three screws (1) from the solenoid.
Remove the solenoid with the armature and
return spring.
100828
Stator Frame Renewal
Loosen the screws on the rear closure cap (2),
but do not remove them.
Remove the hexagon screws (3) running
through the stator housing.
Remove the stator frame (4) with the cover
plate, armature, and commutator end shield.
100836
Armature Remowal
Remove the cover plate from the drive end-
bearing end ring gear.
Carefully press the armature (5) with the
commutator end shield (6) out of the stator by
hand. At the same time, push out terminal 45 (7)
with the sealing rubber (8).
100671