Overrunning Clutch And Planetary Gear Removal - Jeep 1987 Wrangler Workshop Manual

ELECTRICAL
STARTING SYSTEM - BOSCH (4-Cyl. Engine)
Overrunning Clutch and Pla
ictatf
Gear Removal
Remove the sealing rubber.
Remove the planetary gear system with the
overrunning clutch and fork assembly from the
drive end shield.
NOTE: To prevent damage to the planetary gear
system (3) when removing it from the overrun-
ning clutch (4) mount both assemblies onto
Mounting Base KDAL 5047 (5) and stand it up
vertically.
Using KDAL 5028 (6), and a rubber mallet, drive
the stop ring down the input shaft.
6
100676A
Use a suitable set of pliers to bend the ends of
the retainer far enough apart to allow removal
without damaging the drive shaft.
If necessary, carefully remove any burr from the
armature shaft, otherwise damage to the drive
bushing may result.
100675
C-l 64