Twin Clutch Transmission - Jeep Renegade Owner's Handbook Manual

If the vehicle battery is flat and the
ignition key is engaged, the latter is
locked in position. To remove the key
manually see paragraph "Automatic
transmission lever unlock" in chapter "In
an emergency".
GEAR ENGAGEMENT
DISABLING SYSTEM
WITHOUT BRAKE PEDAL
PRESSED
This system prevents you from moving
the gear lever from position P (Park) if
the brake pedal has not been previously
depressed.
To bring the gear lever to a position
other than P (Park), the ignition device
must be in position AVV (engine on or
off) and the brake pedal must be
depressed.
WARNING
117) Never use position P instead of the
electric parking brake. Always engage the
electric parking brake when parking the
vehicle to avoid the accidental movement
of the vehicle.
118) If the P position is not engaged, the
vehicle could move and injure people.
Before leaving the vehicle, make sure that
the gear lever is in position P and that the
electric parking brake is engaged.
119) Do not shift the gear lever to N and
do not stop the engine when driving on a
downhill road. This type of driving is
dangerous and reduces the possibility of
intervening in the case of variation of the
road traffic or surface. You risk losing
control of your vehicle and causing
accidents.
120) Before moving the gear lever from
position P, bring the ignition device to
position MAR and press the brake pedal.
Otherwise, the gear lever may get
damaged.
121) Engage reverse only with the car
stationary, engine at idling speed and
accelerator fully released.
TWIN CLUTCH
TRANSMISSION
GEAR LEVER
The fig 98 lever has the following
positions:
P = Park
R = Reverse
N = Neutral
D = Drive, (automatic forward speed)
"AutoStick": "+" shifting to higher
gear in sequential driving mode or "–"
shifting to lower gear in sequential
driving mode.
98
122)
39) 40)
To select the "sequential" mode, shift
the lever from D (Drive) towards the left.
The reachable positions are + (higher
gear) or - (lower gear). These positions
J0A0146C
113