Toyota T100 1996 Service Manual page 1826

SUPPLEMENTAL RESTRAINT SYSTEM
1996 TOYOTA T100 (RM449U)
− AIRBAG SENSOR ASSEMBLY
INSTALLATION
NOTICE:
Never use SRS parts from another vehicle. When re-
S
placing parts, replace with new ones.
Never reuse the airbag sensor assembly involved in
S
a collision when the airbag has deployed.
Never repair a sensor in order to reuse it.
S
1. INSTALL AIRBAG SENSOR ASSEMBLY
(a) Using a torx wrench, install the airbag sensor assembly
with 3 screws.
Torx wrench: T40 (Part No. 09042−0020 or locally
manufactured tool)
Torque: 21 N·m (210 kgf·cm, 15 ft·lbf)
(b) Connect the connector.
NOTICE:
Installation of the connector is done with the sensor
S
assembly installed. Make sure the sensor assembly
is installed to the specified torque.
If the sensor assembly has been dropped, or there are
S
cracks, dents or other defects in the case, bracket or
connector, replace the sensor assembly with a new
one.
When installing the sensor assembly, take care that
S
the SRS wiring does not interfere with other parts and
is not pinched between other parts.
After installing, shake the sensor assembly to check
S
that there is no looseness.
2. INSTALL REMOVED PARTS
RS−25
RS03T−03