Toyota T100 1996 Service Manual page 1815

RS−14
Connector
Stripped Wire Harness Section
1996 TOYOTA T100 (RM449U)
SUPPLEMENTAL RESTRAINT SYSTEM
Inflater
Cover
R05747
L
M
R05748
Wire Harness
Diameter
AB0163
− STEERING WHEEL PAD AND SPIRAL CABLE
2. DEPLOYMENT WHEN DISPOSING OF STEERING
WHEEL PAD ONLY
NOTICE:
When disposing of the steering wheel pad (with air-
S
bag) only, never use the customers vehicle to deploy
the airbag.
Be sure to follow the procedure given below when de-
S
ploying the airbag.
HINT:
Have a battery ready as the power source to deploy the airbag.
(a) Remove the steering wheel pad.
(See page SR−13
CAUTION:
When storing the steering wheel pad, keep the upper sur-
face of the pad facing upward.
(b) Remove the steering wheel pad connector.
Remove the connector on the rear surface of the steering
wheel pad from the bracket.
(c) Fix steering wheel pad to disc wheel with tire.
(1) Install the 2 bolt with washers in the 2 bolt holes in
the steering wheel pad.
Bolt:
L: 35. mm (1.387 in.)
M: 6.0 mm (0.236 in.)
Pitch: 1.0 mm (0.039 in.)
NOTICE:
Tighten the bolts by hand until the bolts become diffi-
S
cult to turn.
Do not tighten the bolts too much.
S
(2) Using a service−purpose wire harness tie down the
steering wheel pad to the disc wheel.
Wire harness: Stripped wire harness section
2
1.25 mm or more (0.0019 in
HINT:
To calculate the square of the stripped wire harness section:
Square = 3.14 x (Diameter)
or SR−26)
2
. or more).
2
divided by 4