Ip Multicast Router-Timeout - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

IP Multicast Switching Commands

ip multicast router-timeout

Configures the expiry time of IP multicast routers on the specified VLAN or on the system if no VLAN is
specified.
ip multicast [vlan vid] router-timeout [seconds]
Syntax Definitions
vid
seconds
Defaults
parameter
seconds
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
IP Multicast Switching and Routing must be enabled to set the IGMP router timeout on the system and/
or the specified VLANs.
•
If the IGMP router timeout is already configured on the system, then the VLAN configuration will
override the system's configuration.
•
To restore the IGMP router timeout to its default (i.e., 90 seconds) value on the system if no VLAN is
specified, use ip multicast router-timeout followed by the value 0 (e.g., ip multicast router-timeout 0)
or use only ip multicast router-timeout (e.g., ip multicast router-timeout).
•
To restore the IGMP router timeout to its default (i.e., 90 seconds) value on the specified VLAN, use
ip multicast vlan vid router-timeout followed by the value 0 (e.g., ip multicast vlan 2 router-timeout
0) or use only ip multicast vlan vid router-timeout (e.g., ip multicast vlan 2 router-timeout).
Examples
-> ip multicast router-timeout 100
-> ip multicast router-timeout 0
-> ip multicast router-timeout
-> ip multicast vlan 2 router-timeout 100
-> ip multicast vlan 2 router-timeout 0
-> ip multicast vlan 2 router-timeout
Release History
Release 6.6.1; command was introduced.
OmniSwitch 6250 CLI Reference Guide
VLAN on which to apply the configuration.
IGMP router timeout in seconds. Valid range is 1 to 65535.
default
90
November 2009 page 41-23