Table 239: Static Routing Configuration Summary - Juniper JUNOS OS 10.3 - SOFTWARE Manual

Table 239: Static Routing Configuration Summary

Field
Default Route
Default Route
Static Routes
Copyright © 2010, Juniper Networks, Inc.
To configure static routes:
Select >
Configure Routing
1.
of the configured routes.
NOTE: After you make changes to the configuration in this page, you must
commit the changes for them to take effect. To commit all changes to
the active configuration, select
Commit Options to Commit Configuration Changes for details about all
commit options.
Click one:
2.
—To configure a route. Enter information into the routing page as described in
Add
Table 239 on page 1691.
Edit —To modify an existing route. Enter information into the routing page as
described in Table 239 on page 1691.
—To delete an existing route.
Delete
Function
Specifies the default gateway for the
switch.
NOTE: IPv6 is not supported on
EX2200 and EX4500 switches.
Chapter 71: Configuring Layer 3 Protocols
> . The Static Routing page displays details
Static Routing
Commit Options
Your Action
To specify an IPv4 address:
1. Select
2. Type an IP address—for example,
10.10.10.10
3. Enter the subnet mask or address prefix.
For example, 24 bits represents
255.255.255.0
To specify an IPv6 address:
1. Select
2. Type an IP address—
for example,
2001:ab8:85a3::8a2e:370:7334
3. Enter the subnet mask or address prefix.
> . See Using the
Commit
IPv4 .
.
.
IPv6 .
.
1691