Adding Secure Access Devices; Importing A Secure Access Device; Installing And Configuring A Secure Access Device - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SECURE ACCESS DEVICES GUIDE REV 01 Manual

CHAPTER 3

Adding Secure Access Devices

Importing a Secure Access Device

Installing and Configuring a Secure Access Device

Copyright © 2010, Juniper Networks, Inc.
This chapter provides information on how to add a Secure Access device through the
import workflow and also how to verify the imported configuration. This chapter contains
the following procedures:
Importing a Secure Access Device on page 11
Requirements for Importing a Secure Access Device into NSM Through a Reachable
Workflow on page 14
Adding a Secure Access Device Through a Reachable Workflow on page 15
Importing Multiple Secure Access Devices on page 16
Verifying Imported Device Configurations on page 19
You can add a Secure Access device to your existing network by using NSM and importing
its configurations. Using the Add Device Wizard, you can configure a connection between
the management system and the physical device, and then import all device parameters,
policies, objects, VPNs, and so on.
Import a Secure Access device by following these procedures:
Installing and Configuring a Secure Access Device on page 11
1.
Adding a Secure Access Device Through NSM on page 12
2.
Configuring and Activating the NSM agent on the Secure Access Device on page 13
3.
4. Confirming Connectivity and Importing the Secure Access Device
Configuration on page 14
Before you add the Secure Access device to NSM, you must install and configure the
Secure Access device to have logon credentials for an NSM administrator.
11