07/11/02 09:23:08 61TA0000_060_0032
Cylinder Head
Cylinder Head Inspection for Warpage
1. Remove the cylinder head (see page 6-27).
2. Inspect the camshaft (see page 6-36).
3. Check the cylinder head for warpage. Measure
along the edges, and three ways across the center.
• If warpage is less than 0.05 mm (0.002 in.)
cylinder head resurfacing is not required.
• If warpage is between 0.05 mm (0.002 in.) and
0.2 mm (0.008 in.), resurface the cylinder head.
• The maximum resurface limit is 0.2 mm (0.008 in.)
based on a height of 104 mm (4.09 in.).
Cylinder Head Height
Standard (New): 103.95 104.05 mm
*01
PRECISION STRAIGHT EDGE
*02
6-32
TA08AEIA14600017801MAAT00
−
(4.093 4.096 in.)
−