Honda Accord 2008 Manual page 170

07/11/02 09:23:56 61TA0000_060_0047
8. Apply new engine oil to the threads and under the
bolt heads of all cylinder head bolts.
9. Tighten the cylinder head bolts in sequence to
39 N·m (4.0 kgf·m, 29 lbf·ft). Use a beam-type
torque wrench. When using a preset-type torque
wrench, be sure to tighten slowly and do not
overtighten. If a bolt makes any noise while you are
torquing it, loosen the bolt and retighten it from the
first step.
＊０５
10. After torquing, tighten all cylinder head bolts in two
steps (90 ° per step). If you are using a new cylinder
head bolt, tighten the bolt an extra 90 °.
NOTE: Remove the cylinder head bolt if you
tightened it beyond the specified angle, and go
back to step 6 of the procedure. Do not loosen it
back to the specified angle.
＊０６
THIRD STEP
(New bolt)
11. Install the rocker arm assembly (see page 6-45).
12. Install the cam chain (see page 6-15).
13. Connect the following engine wire harness
connectors, and install the wire harness clamps to
the cylinder head:
• Engine coolant temperature (ECT) sensor 1
• Camshaft position (CMP) sensor A (Intake)
• Camshaft position (CMP) sensor B (Exhaust)
• Rocker arm oil control solenoid connector
• Rocker arm oil pressure switch connector
• Evaporative emission (EVAP) canister purge
• Variable valve timing control (VTC) oil control
• Engine oil pressure switch connector
14. Install the two bolts (A) securing the connecting
pipe.
FIRST STEP
15. Install the water bypass hose (B).
SECOND STEP
connector
connector
connector
valve connector
solenoid valve connector
A
6 x 1.0 mm
12 N·m (1.2 kgf·m, 8.7 lbf·ft)
B
＊０７
(cont'd)
6-47