Torque Converter Clutch Solenoid Valve-Shift Solenoid Valve A Test; Torque Converter Clutch Solenoid Valve-Shift Solenoid Valve A Replacement - Honda 2004 Odyssey Service Manual

Automatic Transmission
Torque Converter Clutch Solenoid
Valve - Shift Solenoid Valve A Test
1. Disconnect the 3P connector from the torque
converter clutch solenoid valve/shift control
solenoid valve A.
2. Measure the resistance of the torque converter
clutch solenoid valve between the No. 3 terminal of
the 3P connector and body ground.
Standard: 12 25
3. Measure the resistance of the shift solenoid valve A
between the No. 1 terminal of the 3P connector and
body ground.
Standard: 12 25
4. Replace the torque converter clutch solenoid valve/
shift solenoid valve A if either resistance is out of
specification.
5. If the resistance is within the standard, connect the
No. 1 terminal of the 3P connector to the battery
positive terminal. A clicking sound should be heard.
Connect the No. 3 terminal to the battery positive
terminal. A clicking sound should be heard.
Replace the torque converter clutch solenoid valve/
shift solenoid valve A if no sound is heard.
14-130 14-130
Torque Converter Clutch Solenoid
Valve - Shift Solenoid Valve A
Replacement
NOTE: Torque converter clutch solenoid valve/shift
solenoid valve A must be removed/replaced as an
assembly.
1. Remove the bolt securing the harness cover, then
remove the harness cover from the transmission
hanger.
2. Remove the mounting bolts and torque converter
clutch solenoid valve/shift solenoid valve A (A).
B
3. Clean the mounting surface and fluid passage, and
install a new torque converter clutch solenoid valve
/shift solenoid valve A with a new filter/gasket (B).
4. Install the harness cover on the transmission
hanger.
5. Install the male terminal connector (C) of the
solenoid connector on the harness cover.
6. Check the connector for rust, dirt or oil, then
reconnect it.
A
C
6 x 1.0 mm
12 N·m (1.2 kgf·m,
8.7 lbf·ft)