Rocker Arm And Shaft Disassembly/Reassembly - Honda Accord 2008 Manual

07/11/02 09:23:10 61TA0000_060_0034
Cylinder Head

Rocker Arm and Shaft Disassembly/Reassembly

NOTE:
• Identify each part as it is removed so that each item can be reinstalled in its original position.
• Inspect the rocker arm shaft and rocker arms (see page 6-35).
• If reused, the rocker arms must be installed in the same positions.
• When removing, or installing the rocker arm assembly, do not remove the camshaft holder bolts. The bolts will keep
the holders and rocker arms on the shaft.
• Prior to reassembling, clean all the parts in solvent, dry them, and apply lubricant to any contact points.
• Bundle the intake rocker arms with rubber bands to keep them together as a set.
• When replacing the intake rocker arm assembly, remove the fastening hardware from the new intake rocker arm
assembly.
＊０１
No. 1 No. 1
ROCKER ROCKER
SHAFT HOLDER SHAFT HOLDER
6-34
ＴＡ０８ＡＥＩＡ１４６６６３５１５１１ＭＦＡＴ００
No. 2 No. 2 No. 3 No. 3
ROCKER SHAFT ROCKER SHAFT ROCKER SHAFT ROCKER SHAFT
HOLDER HOLDER HOLDER HOLDER
EXHAUST ROCKER EXHAUST ROCKER
SHAFT SHAFT
EXHAUST ROCKER ARM EXHAUST ROCKER ARM
ASSEMBLY
No. 5 No. 5
ROCKER ROCKER
SHAFT HOLDER SHAFT HOLDER
RUBBER BAND RUBBER BAND
No. 4 No. 4
INTAKE ROCKER INTAKE ROCKER
ROCKER SHAFT ROCKER SHAFT
ARM ASSEMBLY ARM ASSEMBLY
HOLDER HOLDER
INTAKE ROCKER SHAFT INTAKE ROCKER SHAFT