Special Functions For Cycles - Siemens SINUMERIK 840D Programming Manual

1
General

1.8 Special functions for cycles

1.8

Special functions for cycles

Function
To provide an overview and for diagnosis of the cycle
versions, it will be possible as from SW 6.3 to display and
use version screens.
This function can also only be run with HMI software
versions SW 6.3 and higher.
Different overviews are possible with cycle version
display:
•
An overview of all available cycles
•
An overview of the individual directories of data
management for user cycles (CUS.DIR),
manufacturer cycles (CMA.DIR) and Siemens cycles
(CST.DIR)
•
A package overview of all the cycle packages
available in the control
•
Details of the individual packages and cycle files
References:
The version display includes all the *.SPF cycle files and
all the *.COM files of cycle support.
No additional files are required for version display via
directories or of all cycles.
In order to display overviews of individual cycle packages,
each cycle package must hold a package list of all the
associated files.
Package lists
A new file type is introduced for package lists
*.cyp (for cycle package),
in plain text, cycle package list.
The user can create package lists for his own cycle
packages. They must look like this:
1-56
/BAD/, Operator's Guide HMI Advanced
/BEM/, Operator's Guide HMI Embedded
Service display chapter
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition
1
12.97
11.02
© Siemens AG, 2002. All rights reserved