Measure Workpiece/Tool In Automatic - Process Measuring; Measure Workpiece In Automatic; Workpiece Measuring Cycles In Automatic - Siemens SINUMERIK 828D Manual

2.8
Calibrate probe
Edge,
measure
Measure corner
Measure hole
Measure spigot
Measure plane,
angle deviation
kinematics
52
General information on workpiece production
2.8 Measure workpiece/tool in AUTOMATIC - process
measuring

2.8.1 Measure workpiece in AUTOMATIC

For process measuring in Automatic mode, measuring cycles are specifically parameterized for
the measuring task. The input screens of the program editor are used for parameter assignment.
The measuring points to be approached and the measuring task are automatically implemented
in accordance with the measuring program.
The workpiece is measured to determine workpiece tolerances in the production process.
Depending on the measuring cycle used, you can select the following options as the result of
workpiece measurement:
Measurement only without compensations (actual value is measured)
Zero offset compensation (setpoint - actual value deviation)
Tool data compensation (setpoint - actual value deviation)

2.8.2 Workpiece measuring cycles in AUTOMATIC

Practical measuring cycles are provided to facilitate process measuring.
You can select the measuring cycles within the NC program using the Measure mill >
Measure workpiece softkeys.
© Siemens AG All rights reserved SINUMERIK, Manual, Mold-Making with 3- to 5-Axis Simultaneous Milling