Distribution Via Job Lists In The Case Of 1:N - Siemens SINUMERIK 840D sl Commissioning Manual

Solution
In the OB100 (call for FB1), set MCP1BusAdr to 255 and MCP1Stop to "true".
In the OB1, scan the "MMCBTSSready" (DB10.DBX108.3) signal. If this is set, write the
MCP address from DB19.DBB123 (MCP index) to the DB7.DBB27 before removing the MCP
stop bit DB7.DBX62.1. The MCP is now active.
If the "MMCBTSSready" (DB10.DBX108.3) is removed again (operating software switches to
another NCU), the MCP stop bit DB7.DBX62.1 will have to be reset.
5.7

Distribution via job lists in the case of 1:N

Simplified selection of programs
The function is only available in a group of several NCUs ands must be enabled in the
"systemconfiguration.ini " configuration file:
[miscellaneous]
distributeJoblist=true
The sources are located on the local drive of the PCU or the PC.
The distribution of the programs is done by selecting a job list which is located in a
workpiece. The job list may contain COPY and SELECT instructions:
; Copy A.MPF to NCU1:
COPY A.MPF NC=NCU1
; Copy B.MPF to NCU2:
COPY B.MPF NC=NCU2
; Copy all subprograms to all NCUs:
COPY *.SPF *
; Select A.MPF on NCU1 in channel 1.
SELECT A.MPF ch=NCU1,1
; Select B.MPF on NCU2 in channel 2.
SELECT B.MPF ch=NCU2,2
Sequence:
1. If a distributed job list is active during the selection, all distributed programs on the NCU
2. The programs are copied to the corresponding workpieces of the relevant NCU.
3. Existing programs are overwritten without any message.
4. Following a change in a distributed program on the local drive, the modified programs
SINUMERIK Operate (IM9)
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
are deleted without confirmation. If the workpiece on the NCUs is empty, it will be deleted
there.
using the Editor are copied to the corresponding NCU.
5.7 Distribution via job lists in the case of 1:N
Channel menu
47