Installation Of Mechanical Stop, Axis 1 - ABB IRB 1660 Product Manual

C
E
F
G

Installation of mechanical stop, axis 1

The procedure below details how to install the mechanical stop to axis 1.
1
2
3
4
5
6
7
8
Product manual - IRB 1600/1660
3HAC026660-001 Revision: W
2.4.2 Installation of additional mechanical stops on axis 1
Stop pin (standard)
Casted groove
Guiding pin
Hidden stiffening ribs
Action
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply
to the robot, before entering the robot working area.
Place the stop at the base, with the guiding pin in
the casted groove. Turn the stop until the holes
align with the groove.
The stop can be mounted in either direction, result-
ing in differences in the working range.
Drill two holes in the casted groove, with guidance
from the circular and the elliptical hole.
Drill the holes through 10.2 mm.
If drilling in a stiffening rib, drill depth must be min.
30 mm.
Cut the threads M12.
If cutting in a stiffening rib, thread depth must be
min. 23 mm.
Fit the stop to the base without tightening the bolts.
Turn axis 1 manually and check the working area
between the stops.
Tighten the bolts.
Adjust the software working range limitations (sys-
tem parameter configuration) to correspond to the
mechanical limitations.
© Copyright 2006-2018 ABB. All rights reserved.
2 Installation and commissioning
Note/Illustration
xx0400001288
Also see the figure
mechanical stop, axis 1 on
page 102.
How to release the holding brake
of the axis motor is detailed in
section Manually releasing the
brakes on page
2 pcs/stop: M12 x 40, tightening
torque: 85 Nm.
The system parameters that must
be changed (Upper joint bound
and Lower joint bound) are de-
scribed in Technical reference
manual - System parameters.
Continues on next page
Continued
Illustration,
66.
103