ABB IRB 1660 Product Manual page 285

Required equipment
Equipment, etc.
Rot. ac motor incl pinion
O-ring
Standard toolkit
Power supply
Rotation tool, motor
Other tools and procedures may
be required. See references to
these procedures in the step-by-
step instructions below.
Circuit diagram
Pendulum Calibration tool
Deciding calibration routine
Decide which calibration routine to be used, based on the information in the table.
Depending on which routine is chosen, action might be required prior to beginning
the repair work of the robot, see the table.
1
Product manual - IRB 1600/1660
3HAC026660-001 Revision: W
CAUTION
Always cut the paint with a knife and grind the paint edge when disassembling
parts. See Cut the paint or surface on the robot before replacing parts on page
Action
Decide which calibration routine to use for
calibrating the robot.
• Reference calibration. External cable
packages (DressPack) and tools can
stay fitted on the robot.
• Fine calibration. All external cable
packages (DressPack) and tools
must be removed from the robot.
If the robot is to be calibrated with refer-
ence calibration:
Find previous reference values for the axis
or create new reference values. These val-
ues are to be used after the repair proced-
ure is completed, for calibration of the ro-
bot.
If no previous reference values exist, and
no new reference values can be created,
then reference calibration is not possible.
© Copyright 2006-2018 ABB. All rights reserved.
4.6.6 Replacement of motor, axis 4, 1600ID/1660ID
Art. no. Note
For spare part num-
ber, see:
• Spare part
lists on
page 387
3HAB3772-81
The contents are defined in section
Standard tools on page
- 24 VDC, max. 1,5 A.
For releasing the brakes.
For adjusting the gear play.
These procedures include refer-
ences to the tools required.
See
See
Note
Follow the instructions given in the refer-
ence calibration routine on the FlexPendant
to create reference values.
Creating new values requires possibility to
move the robot.
Read more about reference calibration for
Axis Calibration in
routine on page
Read more about reference calibration for
Pendulum Calibration in Operating manu-
al - Calibration Pendulum.
4 Repair
Continued
383.
Circuit diagram on page 389.
Special tools on page 384.
Reference calibration
350.
Continues on next page
159.
285