ABB IRB 1660 Product Manual page 316

4 Repair
4.6.11 Replacement of motor, axis 6, IRB 1600ID
Continued
Equipment
Standard toolkit
Other tools and procedures may
be required. See references to
these procedures in the step-by-
step instructions below.
Circuit diagram
Deciding calibration routine
Decide which calibration routine to be used, based on the information in the table.
Depending on which routine is chosen, action might be required prior to beginning
the repair work of the robot, see the table.
1
Removal of motor axis 6
1
2
Continues on next page
316
CAUTION
Always cut the paint with a knife and grind the paint edge when disassembling
parts. See Cut the paint or surface on the robot before replacing parts on page
Action
Decide which calibration routine to use for
calibrating the robot.
• Reference calibration. External cable
packages (DressPack) and tools can
stay fitted on the robot.
• Fine calibration. All external cable
packages (DressPack) and tools
must be removed from the robot.
If the robot is to be calibrated with refer-
ence calibration:
Find previous reference values for the axis
or create new reference values. These val-
ues are to be used after the repair proced-
ure is completed, for calibration of the ro-
bot.
If no previous reference values exist, and
no new reference values can be created,
then reference calibration is not possible.
If the robot is to be calibrated with fine
calibration:
Remove all external cable packages
(DressPack) and tools from the robot.
Action
Move the upper arm to the synchronization position.
Decide which calibration routine to use, and take
actions accordingly prior to beginning the repair
procedure.
© Copyright 2006-2018 ABB. All rights reserved.
Art. no.
-
-
Note
Follow the instructions given in the refer-
ence calibration routine on the FlexPendant
to create reference values.
Creating new values requires possibility to
move the robot.
Read more about reference calibration for
Axis Calibration in
routine on page
Read more about reference calibration for
Pendulum Calibration in Operating manu-
al - Calibration Pendulum.
Note
Product manual - IRB 1600/1660
Note
Standard tools on page 383
These procedures include
references to the tools re-
quired.
See Circuit diagram on
page 389.
159.
Reference calibration
350.
3HAC026660-001 Revision: W