Draper Deck Drive Roller - MacDon D65 Operator's Manual

Installing Draper Idler Roller
1. Position the stub shaft into the idler roller in the forward
arm (B) on the deck.
2. Push on the roller to slightly deflect the forward arm so
the stub shaft at the rear of the roller can be slipped
into the rear arm (C).
3. Install bolts (A) with washers, and torque to 70 ft·lbf
(93 N·m).
4. Wrap the draper over the idler roller, close the draper,
and set the tension. Refer to
page 163.
5. Run the machine and verify the draper tracks correctly.
Adjust the draper tracking if required. Refer to
Adjusting Header Draper Tracking, page

Draper Deck Drive Roller

Removing Draper Drive Roller
1. If draper connector is not visible, engage the header until the connector is accessible, preferably close to the
outboard end of the deck.
WARNING
To avoid bodily injury or death from unexpected start-up or fall of raised machine, always stop engine,
remove key, and engage safety props before going under machine for any reason.
2. Raise header and reel, and then shutdown the engine.
3. Engage header lift cylinder safety props and reel lift cylinder safety props.
4. Loosen draper by
counterclockwise.
147725
MAINTENANCE AND SERVICING
5.7.2 Installing Drapers,
170.
turning adjuster bolt
5.7.6
Figure 5.120: Idler Roller
(A)
Figure 5.121: Tensioner
177
Revision A