Installing Draper Idler Roller; Removing Draper Deck Drive Roller - MacDon D65 Operator's Manual

Installing Draper Idler Roller

The roller needs to be installed after it has been repaired or replaced
1. Position the stub shaft into the idler roller in forward
arm (B) on the deck.
2. Push on the roller to slightly deflect the forward arm so the
stub shaft at the rear of the roller can be slipped into rear
arm (C).
3. Install bolts (A) with washers, and torque them to 93 Nm
(70 lbf·ft).
4. Wrap the draper over the idler roller, close the draper, and
set the tension. For instructions, refer to
Side Drapers, page 180.
5. Run the machine and verify the draper tracks correctly.
Adjust the draper tracking if required. For instructions, refer
to 5.7.4 Adjusting Side Draper Tracking, page

Removing Draper Deck Drive Roller

The roller needs to be removed when repairing or replacing it.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key before leaving the operator's seat, and always engage the safety props before going under the
machine for any reason.
WARNING
To prevent bodily injury from the fall of a raised reel, always engage the reel safety props before going under the
raised reel for any reason.
NOTE:
If the draper joint is not visible, engage the header until the connector is accessible (preferably close to the outboard end
of the deck).
1. Raise the reel fully.
2. Raise the header fully.
3. Shut down the engine, and remove the key from the ignition.
4. Engage the header safety props. For instructions, refer to the windrower operator's manual.
5. Engage the reel safety props. For instructions, refer to
214327
MAINTENANCE AND SERVICING
5.7.2 Installing
Figure 5.131: Idler Roller
184.
Engaging Reel Safety Props, page
192
A
B
33.
A
C
Revision B