Table of Contents
Advertisement
14. Push latch (A) to unlock platform (B).
15. Pull platform (A) toward the cab until it stops and the latch
is engaged.
16. If this is the first time the header is connected to the
windrower, calibrate the header. For instructions, refer to
5.6 Calibrating Header on HarvestTouch
5.1.4 Detaching A40DX Auger Header
Detaching the A40DX electrical and hydraulic connections from the windrower is a simple procedure, thanks to the
multicoupler. There is an additional step to perform if you are swapping a rotary disc header for an auger header.
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key before leaving the operator's seat, and always engage the safety props before going under the
machine for any reason.
DANGER
Ensure that all bystanders have cleared the area.
262175
ATTACHING HEADERS TO WINDROWER
™
Display, page
227.
109
B
Figure 5.27: Left Platform
Figure 5.28: Left Platform
A
1015478
A
Revision A
Advertisement
Table of Contents
