Repositioning Conditioner Drive Speed Sensor - Model Year 2018 And Later - MacDon R113 Installation Instructions Manual

3.2.1 Repositioning Conditioner Drive Speed Sensor – Model Year 2018 and Later
Reposition the speed sensor as follows:
NOTE:
This procedure also applies to model year 2017 headers that have an updated steel speed sensor and mounting bracket as
shown in Figure 3.16, page
1. Remove nut (A) from sensor (B).
2. Reinstall sensor (B) into hole (C).
3. Make sure there is a 2–3 mm (1/16–1/8 in.) gap (A)
between pulley (B) and sensor (C). Adjust gap as required
using nuts (D). Make sure the sensor is parallel with the
pulley.
NOTE:
Additional vertical alignment of the sensor may be achieved
by moving the bracket up or down retaining nut (E). Loosen
nut (E), adjust bracket, and tighten nut (E) to 58 Nm
(43 lbf·ft).
4. Tighten sensor nuts (D) to 12 Nm (9 lbf·ft).
215276
INSTALLATION INSTRUCTIONS
13.
C
B
Figure 3.16: Speed Sensor – Model Year 2018
and Later
E
Figure 3.17: Gap between Sensor and Pulley
13
A
A
A D
B
C
Revision A