7. Remove lynch pin (A) and clevis pin securing forming
shield (B) to bolt and spacer (C). Repeat this step at the
opposite side.
8. Dismount forming shield (B) from bolts and spacers (C).
9. Reattach the clevis pin and the lynch pin to the forming
shield.
10. Remove the forming shield.
4.4.2 D2 SP Series Draper Header
To attach the header to the windrower, follow the procedures provided here in the order presented.
Attaching Draper Header Supports
The draper header supports are required to attach the header to a windrower.
NOTE:
For headers that were previously attached to a combine, order draper header supports bundle B7266.
DANGER
To prevent bodily injury or death from the unexpected start-up of the machine, always stop the engine and remove the
key from the ignition before making adjustments to the machine.
262170
OPERATION
Figure 4.111: Forming Shield Secured to Front of
Windrower Legs
176
A
B
C
Revision A