Ip Pim Neighbor-Filter - Dell Z9500 Reference Manual

Dell(conf)#int tengig 1/1
Dell(config-if-te-1/1)# ip pim ingress-interface-map map1

ip pim neighbor-filter

To prevent a router from participating in protocol independent multicast (PIM), configure this feature.
Z9500
Syntax
ip pim [vrf vrf-name] neighbor-filter {access-list}
To remove the restriction, use the no ip pim [vrf vrf-name] neighbor-
filter {access-list} command.
Parameters
vrf vrf-name
access-list
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.5(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.8.1.0
7.6.1.0
Usage Do not enter this command before creating the access-list.
Information
PIM-Sparse Mode (PIM-SM)
(OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to prevent that VRF from participating in PIM.
NOTE: Applies to specific VRF if input is provided, else
applies to default VRF.
Enter the name of a standard access list. Maximum 16
characters.
Description
Added support for VRF. Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.
1343