Ip Pim Neighbor-Filter - Dell Z9500 Command Reference Manual

Version
8.3.12.0
8.4.1.0
Example
Dell(conf)# ip access-list standard map1
Dell(config-std-nacl)# permit 224.0.0.1/24
Dell(config-std-nacl)#exit
Dell(conf)#int tengig 1/1
Dell(config-if-te-1/1)# ip pim ingress-interface-map map1

ip pim neighbor-filter

To prevent a router from participating in protocol independent multicast (PIM), configure this feature.
Z9500
Syntax
ip pim [vrf vrf-name] neighbor-filter {access-list}
To remove the restriction, use the no ip pim [vrf vrf-name] neighbor-
filter {access-list} command.
Parameters
vrf vrf-name
access-list
Defaults none
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.5(0.1)
9.0.2.0
8.3.19.0
8.3.11.1
PIM-Sparse Mode (PIM-SM)
Description
Introduced on the S4810.
Introduced
(OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to prevent that VRF from participating in PIM.
NOTE: Applies to specific VRF if input is provided, else
applies to default VRF.
Enter the name of a standard access list. Maximum 16
characters.
Description
Added support for VRF. Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
1381