Ip Pim Neighbor-Filter; Ip Pim Query-Interval - Dell Force10 S4810P Reference Manual

FTOS(conf)#int gig 1/1
FTOS(config-if-gi-1/1)# ip pim ingress-interface-map map1

ip pim neighbor-filter

Configure this feature to prevent a router from participating in protocol independent multicast (PIM).
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip pim neighbor-filter {access-list}
To remove the restriction, use the no ip pim neighbor-filter {access-list}
command.
Parameters
access-list
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.8.1.0
Version 7.6.1.0
Usage Do not enter this command before creating the access-list.
Information

ip pim query-interval

Change the frequency of PIM Router-Query messages.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ip pim query-interval seconds
To return to the default value, use the no ip pim query-interval seconds
command.
Parameters
seconds
Defaults 30 seconds
Command Modes INTERFACE
Command History
Version 8.3.11.1
Version 8.3.7.0
Enter the name of a standard access list. Maximum 16 characters.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series and S-Series.
Introduced on the E-Series.
Enter a number as the number of seconds between router query
messages. The range: 0 to 65535. The default is 30 seconds.
Introduced on the Z9000.
Introduced on the S4810.
1241