Table of Contents
Advertisement
Installing an AC or DC Power Module Slot Cover
Table 2: Power Module LED Status Indicator Lights
LED Name
Input OK
Output OK
Fault
Installing an AC or DC Power Module Slot Cover
This section describes how to install a PM slot cover into an empty PM slot on an AC or DC power tray.
Prerequisites
Before performing this task, you must remove the cosmetic grilles and install the PMs to the required
configuration in each power tray.
Required Tools and Equipment
• ESD-preventive wrist strap
• AC or DC PM slot cover (Cisco PID A9K-PEM-V2-FILR)
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
18
Color
Meaning
Green
On: The input voltage is present and within regulation range.
Blinking: The input voltage is present but out of regulation range.
Off: The input voltage is not present.
Green
On: The output voltage is on.
Blinking: The PM is in a power limit or Over Current condition.
Off: The output voltage is off.
Red
On: An internal fault is detected within the PM.
Off: No internal faults detected on the PM.
Installing the Power Components
Advertisement
Table of Contents
