Ruijie Networks RG-S2600E Series Cli Reference Manual page 1138

S2600E CLI Reference Guide
Management
Parameter
description
Default
Command
mode
Usage
guidelines
Examples
Chapter 2 Configuration Commands of Configuration File
Parameter Description
The
file1 (including the path where the file is, it is
optional)
The second configuration file name
file2 (including the path where the file is, it is
optional)
If the file1 and file2 are both not specified, then assume the
file1 to the current configuration on the device and file2 to
the config.text file in the flash.
Privileged mode.
By executing the show archive config differences
command, users can see the configurations (the
configurations here do not include the "!" in the
configuration file) that only exist in one of the
configuration files. The type of these configurations
depends on the order of the specified configuration file.
And in front of each configuration information, there is a
identifier, which is used to identify the type of this
configuraiton information. Compared with the file1 , the
identifiers and meanings are shown as below:

With the "-" in front, the command does not exit in
the file2 but in the file1.

With the "+" in front, the command exist in the file2
but not in the file1.
The example following assumes that the content of the
config_bak1.text and config_bak2.text are shown as below:
config_bak1.text
ip dhcp snooping verify
mac-address
ip dhcp snooping
informa
tion
option
interface GigabitEthernet
first configuration
config_bak2.text
ip dhcp
ip dhcp
bootp-bind
interface GigabitEthernet
file name
snooping
informa
tion
option
snooping