Table of Contents
Advertisement
13) Throttle Cable
Adjustment of Throttle Cable
1.
Check position of cable on low speed and high speed
sides.
2.
Set throttle grip to slowest position, and fully pull
choke knob to close choke valve.
Lock nut 1 while applying tension to outer wire by
3.
pulling it with a hand to fix low speed side wire.
The wire is in proper state if pushing inner wire at
the center makes deflection of about 1mm.
4.
Repeat above steps for high speed side wire, and fix
it.
5.
Return the choke knob to full open position.
To confirm the slowest position of throttle grip, check
gap between projection of throttle drum and dent of
opener section. The gap is acceptable if it is in the
range between 0.5mm and 1mm.
Repeat steps 2. to 4. if necessary.
4st 4/5/6 2020
1
3
3-15
Advertisement
Table of Contents
