Remote Control Box Location; Remote Control Cable Length - TOHATSU BFT 200D Owner's Manual

INSTALLATION
<Remote Control Box Location>

Remote Control Box Location

REMOTE
CONTROL
LEVER
REMOTE
CONTROL BOX
Install the remote control box in the
position where is easy to operate the
remote control lever and switches.
Mechanical wire type:
Be sure that there are no obstacles on
the route of the control cable.
The control box position of the D1
type, D2 type, R2 type and the R3
type should be determined in the
same manner.
54
<Remote Control Cable Length>
(Mechanical wire type)
REMOTE
CONTROL
CABLES
(Mechanical
wire type)
Measure the distance from the control
box to the outboard motor along the
cable routing.
Recommended cable length is
300 – 450 mm (11.8 – 17.7 in) longer
than the measured distance.
Set the cable along the predetermined
route and be sure that it is long
enough to the route.
Connect the cable to the engine and be
sure it is not kinked, bent sharp, pulled
taut, or interfered while steering.
https://www.boat-manuals.com/
Do not bend the remote control
cable as sharp as its route diameter
is 300 mm (11.8 in) or less, or it
affects the service life of the cable
and the remote control lever
operation.