Untagged - Dell Z9500 Command Reference Manual

untagged

Add a Layer 2 interface to a VLAN as an untagged interface.
Z9500
Syntax
untagged interface
To remove an untagged interface from a VLAN, use the no untagged interface
command.
Parameters
interface
Defaults All interfaces in Layer 2 mode are untagged.
Command INTERFACE VLAN
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.5.1.0
8.3.7.0
7.6.1.0
7.5.1.0
pre-6.2.1.1
Layer 2
Enter the following keywords and slot/port or number
information:
• For a port channel interface, enter the keywords port-
channel then a number. The range is from 1 to 512.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Description
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
1163