7.8.5
Checking and replacing the transfer roller
1. Handling precautions
-
Wear gloves to avoid touching the drum surface with your bare hands.
-
Do not allow oil or fingerprints to come in contact with the surface.
-
Do not hit or scratch the surface.
-
Make sure you do not get any bits of thread, etc. on the surface.
-
Do not allow solvent, such as thinner, to come in contact with the surface.
-
Keep away from a source of heat.
2. Cleaning procedure
If bits of thread or similar adhere to the surface, remove them with gloves or a pair of tweezers. Be
careful that the roller surface is not damaged by the points of the tweezers.
© 2013-2017 TOSHIBA TEC CORPORATION All rights reserved
e-STUDIO2006/2306/2506/2007/2307/2507/2303A/2303AM/2803AM/2309A/2809A
7 - 35
PREVENTIVE MAINTENANCE (PM)
7