Toshiba e-STUDIO206L Service Manual page 43

Notes:
• "-" means "Not acceptable".
• The bridge unit (KN-2520) is necessary for installation of the finisher (MJ-1033, MJ-1101, MJ-
1106).
• The finisher (MJ-1101/1106) is necessary for installation of the hole punch unit (MJ-6103N/E/
F/S).
• The finisher (MJ-1032) is necessary for installation of the hole punch unit (MJ-6007N/E/F/S).
• The finisher (MJ-1033) is necessary for installation of the hole punch unit (MJ-6008N/E/F/S).
• The antenna (GN-3010) is necessary to enable the wireless LAN Module (GN-1060) and
Bluetooth module (GN-2020).
• Only one Antenna (GN-3010) can be installed in the Bluetooth Module (GN-2020), while up to
two can be installed in the Wireless LAN Module (GN-1060).
• The Work Table (KK-4550) and the e-BRIDGE ID Gate (KP-2004/2005) cannot be installed
together.
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
SPECIFICATIONS / ACCESSORIES / OPTIONS / SUPPLIES
2 - 19
2