Transfer Belt Cleaning Blade / Blade Seal - Toshiba e-STUDIO2330C Service Manual

14.6.2 Transfer belt cleaning blade
(1) Take off the transfer belt cleaning unit.
 P.14-11 "14.6.1 Transfer belt cleaning
unit"
(2) Remove 2 screws, and then take off the
transfer belt cleaning blade.
(3) Remove 2 screws, and then take off the
recovery blade.
(4) Remove the blade seals (both front and rear
sides).
Notes:
1. When the blade seals are being attached,
attach them on the position shown in the
figure (by slightly pushing it to the
direction of the arrow).
2. After the blade seals have been attached,
be sure that no gap is left between the
blade seals and the edge of the transfer
belt cleaning blade.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
/ Blade seal
Recovery blade
Fig. 14-11
Blade seal
Fig. 14-12
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
14 - 13
Transfer belt
cleaning blade
Blade seal
Transfer belt
cleaning blade
Blade seal
Transfer belt
cleaning blade
TRANSFER UNIT
14