Fujitsu FR60 Hardware Manual page 427

Hide thumbs Also See for FR60:

Table of Contents

■ Example of Setting Baud Rates and U-TIMER Reload Values

Table 14.1-3 gives examples of setting values for baud rates and U-TIMER reload values in asynchronous

(start-stop synchronization) mode. Table 14.1-4 gives examples of setting values for baud rates and U-

TIMER reload values in CLK synchronous mode.

A frequency in the tables represents a peripheral machine clock frequency. UCC1 is a value to be set in the

UCC1 bit of the UTIMC register for the U-TIMER. A dash (-) in the tables means that the baud rate cannot

be used because the error exceeds plus minus 1%.

The U-Timer reload value is displayed as a decimal value.

Table 14.1-3 Example of Setting Values for Baud Rates and U-TIMER Reload Values in Asynchronous

(Start-stop Synchronization) Mode

φ = Peripheral machine clock frequency

Note: The error range is -1% to +1%.

Table 14.1-4 Example of Setting Values for Baud Rates and U-TIMER Reload Values in CLK Synchronous

Baud rate (bps)

φ = Peripheral machine clock frequency

*: The error range is -1% to +1%.

1301(UCC1=0)

1040(UCC1=1)

Mb91350a series