Fujitsu FR60 Hardware Manual page 17

Page
494 16.3.1 Overview of Opera-
tion
534 17.1 Outline of Flash
Memory
536
537, 538
544 17.2.2 Flash Memory Wait
Register (FLWC)
559 17.5.2 Data Writing
568 18.1 Basic Configuration
of MB91F355A/F353A/
F356B/F357B
Serial Programming Con-
nection
569 18.2 Pins Used for Fujitsu
Standard Serial Onboard
Writing
573 18.5 Other Precautionary
Information
584 APPENDIX A I/O Map
The vertical lines marked in the left side of the page show the changes.
Changes (For details, refer to main body.)
"● Fly-by transfer (I/O → memory)" was changed.
(Access areas used for MB91350A fly-by transfer must be external areas. →
Access areas used for MB91F355A/F356B/F357B/355A fly-by transfer must
be external areas.)
"Summary of 17.1 Outline of Flash Memory" was changed.
"Figure 17.1-3 Memory Map of MB91F356B Flash Memory" was added.
"■ Sector Address Table of Flash Memory" was changed.
"[Bits 2 to 0] WTC2, WTC1, and WTC0 (wait cycle bits)" was changed.
"■ How to Specify Address" was changed.
"■ Basic Configuration of MB91F355A/F353A/F356B/F357B Serial Pro-
gramming Connection" was changed.
("Either a program operating in single-chip mode or a program operating in
internal ROM external bus mode is selected to write." was added.)
"Table 18.2-1 Function of Pins Used for Fujitsu Standard Serial Onboard Writ-
ing" was changed.
"● Oscillation Clock Frequency" was changed.
(4.0 MHz and 12.0 MHz → 10.0 MHz and 12.5 MHz)
"● Port State for Write Operations on Flash Memory" was changed.
(reset state except → initial state in the single-chip mode except)
"Address 00009C of Table A-1 I/O Map" was changed.
H
("*1" was added.)
xiii