Fujitsu FR60 Hardware Manual page 33

Table 1.5-1 Pin Functions (3 / 13)
Pin number
176 pins 120 pins
87 73
88 74
89 75
I/O
Pin name circuit
type
SI6
AIN0
D
TRG0
PM0
SO6
BIN0
D
TRG1
PM1
SCK6
ZIN0
D
TRG2
PM2
Function
[SI6] is data input for serial I/O6.
Since this input is always used when serial I/O6 input is
operating, output using the port must be stopped beforehand
unless this operation is the intended operation.
[AIN0] is input for the up/down timer.
Since this input is always used when input is allowed,
output using the port must be stopped beforehand unless
this operation is the intended operation.
[TRG0] is external trigger input for PPG timer 0.
Since this input is always used when input is allowed,
output using the port must be stopped beforehand unless
this operation is the intended operation.
[PM0] is a general-purpose I/O port.
This function can be used as a port when serial I/O, up/
down timer, and PPG timer output are not used.
[SO6] is data output from serial I/O6.
This function is valid when data output from serial I/O6 is
allowed.
[BIN0] is input for the up/down timer.
Since this input is always used when input is allowed,
output using the port must be stopped beforehand unless
this operation is the intended operation.
[TRG1] is external trigger input for PPG timer 1.
Since this input is always used when input is allowed,
output using the port must be stopped beforehand unless
this operation is the intended operation.
[PM1] is a general-purpose I/O port.
This function can be used as a port when serial I/O, up/
down timer, and PPG timer output are not used.
[SCK6] is clock I/O for serial I/O6.
This function is valid when clock output from serial I/O6 is
allowed or when external shift clock input is used.
[ZIN0] is input for the up/down timer.
Since this input is always used when input is allowed,
output using the port must be stopped beforehand unless
this operation is the intended operation.
[TRG2] is external trigger input for PPG timer 2.
Since this input is always used when input is allowed,
output using the port must be stopped beforehand unless
this operation is the intended operation.
[PM2] is a general-purpose I/O port.
This function can be used as a port when serial I/O, up/
down timer, and PPG timer output are not used.
15