Siemens G130 List Manual page 230

2 Parameters
2.2 List of parameters
14:
15:
16:
17:
18:
19:
20:
21:
22:
23:
24:
25:
26:
27:
28:
29:
30:
31:
32:
Dependency: Only the unit of the technology controller parameters are switched over (unit group 9_1).
Refer to: p0596
Note: When switching over from % into another unit, the following sequence applies:
- set p0596
- set p0595 to the required unit
p0596 Technological unit reference quantity / Tech unit ref qty
VECTOR_G Can be changed: T
(Tech_ctrl)
Data type: FloatingPoint32
P-Group: -
Not for motor type: -
Min
0.01
Description: Sets the reference quantity for the technological units.
When changing over using changeover parameter p0595 to absolute units, all of the parameters involved refer to the
reference quantity.
Dependency: Refer to: p0595
Notice: When changing over from one technological unit into another, or when changing the reference parameter, a
changeover is not made.
p0600[0...n] Motor temperature sensor for monitoring / Mot temp_sensor
VECTOR_G Can be changed: C2(3), U, T
Data type: Integer16
P-Group: Motor
Not for motor type: -
Min
0
Description: Sets the sensor to monitor the motor temperature.
The sensor type used is set in p0601.
Value: 0:
1:
2:
3:
10:
11:
20:
21:
Dependency: Refer to: r0458, p0601, p0603
230
kg/h
t/min
t/h
N
kN
Nm
psi
°F
gallon/s
inch³/s
gallon/min
inch³/min
gallon/h
inch³/h
lb/s
lb/min
lb/h
lbf
lbf ft
No sensor
Temperature sensor via encoder 1
Temperature sensor via encoder 2
Temperature sensor via encoder 3
Temperature sensor via a BICO interconnection
Temperature sensor via Motor Module / CU terminals
Temperature sensor via a BICO interconnection p0608
Temperature sensor via a BICO interconnection p0609
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
340.28235E36
Calculated: CALC_MOD_ALL
Dyn. index: MDS, p0130
Unit group: -
Scaling: -
Max
21
List Manual (LH2), 07/2016, A5E03263479A
Access level: 1
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
1.00
Access level: 2
Func. diagram: 8016
Unit selection: -
Expert list: 1
Factory setting
0
SINAMICS G130/G150