Siemens G130 List Manual page 196

2 Parameters
2.2 List of parameters
r0467[0...27] Encoder 3 identification number/serial number / Enc3 ID_no/Ser_no
VECTOR_G Can be changed: -
Data type: Unsigned8
P-Group: Encoder
Not for motor type: -
Min
-
Description: Displays the identification/serial number of encoder 3.
Index 0 = first character of the identification number
...
Index x = 20 hex (blank) --> separation between the identification number of serial number
Index x + 1 = 2F hex (slash) --> separation between the identification number of serial number
Index x + 2 = 20 hex (blank) --> separation between the identification number of serial number
Index x + 3 = first character of the serial number
...
Index y with contents = last character of the serial number
Dependency: Refer to: r0460, r0461, r0462, r0463, r0464
Notice: An ASCII table (excerpt) can be found, for example, in the appendix to the List Manual.
Note: The individual characters of the identification number/serial number are available coded as ASCII characters.
r0469[0...2] Absolute encoder linear measuring step / Enc lin meas step
VECTOR_G Can be changed: -
Data type: Unsigned32
P-Group: Encoder
Not for motor type: -
Min
- [nm]
Description: Displays the resolution of the absolute position for a linear absolute encoder.
Index: [0] = Encoder 1
[1] = Encoder 2
[2] = Encoder 3
Dependency: Refer to: p0422, p9514
r0469 Absolute encoder linear measuring step / Enc lin meas step
ENC Can be changed: -
Data type: Unsigned32
P-Group: Encoder
Not for motor type: -
Min
- [nm]
Description: Displays the resolution of the absolute position for a linear absolute encoder.
Dependency: Refer to: p0422, p9514
196
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
-
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
- [nm]
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
- [nm]
List Manual (LH2), 07/2016, A5E03263479A
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
- [nm]
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
- [nm]
SINAMICS G130/G150