Siemens G130 List Manual page 973

For value = D0 hex:
The following parameters are copied after starting the copy function:
p9601 --> p9801, p9602 --> p9802, p9610 --> 9810, p9611 --> 9811, p9621 --> 9821, p9622 --> 9822, p9650 -->
p9850, p9651 --> p9851, p9652 --> p9852, p9658 --> p9858, p9697 --> p9897
p9700 SI Motion copy function / SI Mtn copy fct
TM54F_MA Can be changed: C2(95), U, T
Data type: Integer16
P-Group: Safety Integrated
Not for motor type: -
Min
0000 hex
Description: Setting to start the required copy function.
After starting, the appropriate parameters are copied from the Control Unit to the Motor Module.
Once copying is complete, the parameter is automatically reset to zero.
Value: 0:
29:
87:
204:
Note: For value = 57 hex:
The value can only be set if the safety commissioning mode is set and the Safety Integrated password was entered.
SI: Safety Integrated
p9701 Acknowledge SI motion data change / Ackn SI Mtn dat
VECTOR_G Can be changed: C2(95), U, T
Data type: Integer16
P-Group: Safety Integrated
Not for motor type: -
Min
0000 hex
Description: Setting to transfer the reference checksums from the associated actual checksums after changes (SI parameters,
hardware).
After transferring the reference checksums, parameters are automatically reset to zero.
Value: 0:
172:
220:
236:
Dependency: Refer to: r9398, p9399, r9728, p9729, r9798, p9799, r9898, p9899
Note: For value = AC and DC hex:
These values can only be set if the safety commissioning mode is set and the Safety Integrated password was
entered.
p9701 Acknowledge SI motion data change / Ackn SI Mtn dat
TM54F_MA, Can be changed: C2(95), U, T
TM54F_SL
Data type: Integer16
P-Group: Safety Integrated
Not for motor type: -
Min
0000 hex
Description: Setting to transfer the reference checksums from the associated actual checksums after changes (SI parameters,
hardware).
After transferring the reference checksums, parameters are automatically reset to zero.
Value: 0:
172:
236:
SINAMICS G130/G150
List Manual (LH2), 07/2016, A5E03263479A
[00 hex] Copy function ended
[1D hex] Start copy function node identifier
[57 hex] Start copy function SI parameters
[CC hex] Start copy function TM54F communication clock cycles
[00 hex] Data unchanged
[AC hex] Acknowledge data change complete
[DC hex] Acknowledge SI basic parameter change
[EC hex] Acknowledge hardware CRC
[00 hex] Data unchanged
[AC hex] Acknowledge data change complete
[EC hex] Acknowledge hardware CRC
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
00CC hex
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
00EC hex
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
00EC hex
2 Parameters
2.2 List of parameters
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0000 hex
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0000 hex
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0000 hex
973