Siemens G130 List Manual page 593

For bit 11:
The infeed is faulted or has failed. Check the infeed and the surroundings (line supply, filter, reactors, fuses, ...).
Check the closed-loop infeed control.
For bit 15:
Group fault. Determine the precise cause of the fault using the commissioning tool.
r3114.9...11 CO/BO: Messages status word global / Msg ZSW global
CU_G130_PN, Can be changed: -
CU_G150_PN,
Data type: Unsigned16
CU_G130_DP,
P-Group: Displays, signals
CU_G150_DP
Not for motor type: -
Min
-
Description: Displays the global status word for messages.
The appropriate bit is set if at least one message is present at the drive objects.
Bit field: Bit
09
10
11
Note: The status bits are displayed with delay.
r3115[0...63] Fault drive object initiating / F DO initiating
All objects Can be changed: -
Data type: Integer32
P-Group: Messages
Not for motor type: -
Min
-
Description: Displays the drive object number of the initiating drive object for this fault as integer number.
Value = 63:
The fault was initiated by the drive object itself.
Dependency: Refer to: r0945, r0947, r0948, r0949, r2109, r2130, r2133, r2136, r3120, r3122
Note: The buffer parameters are cyclically updated in the background (refer to status signal in r2139).
The structure of the fault buffer and the assignment of the indices is shown in r0945.
p3116 BI: Suppress automatic acknowledgment / Ackn suppress
CU_G130_PN, Can be changed: U, T
CU_G150_PN,
Data type: Unsigned32 / Binary
CU_G130_DP,
P-Group: Messages
CU_G150_DP
Not for motor type: -
Min
-
Description: Sets the signal source for the automatic acknowledgment of Control Unit faults.
BI: p3116 = 0 signal
Acknowledgeable faults are automatically acknowledged on the Control Unit.
Control Unit faults with LOCAL propagation are passed on to the first active drive object.
BI: p3116 = 1 signal
Acknowledgeable faults are not automatically acknowledged on the Control Unit.
Control Unit faults with LOCAL propagation are not passed on.
Dependency: Refer to: p2102, p2103, p2104, p2105, p3981
Note: When selecting a standard telegram, the BICO interconnection for control signal STW1.10 (master control by PLC) is
automatically established.
SINAMICS G130/G150
List Manual (LH2), 07/2016, A5E03263479A
Signal name
Group alarm present
Group fault present
Safety group message present
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
-
1 signal
Yes
Yes
Yes
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
-
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
-
2 Parameters
2.2 List of parameters
Access level: 2
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
0 signal
No
No
No
Access level: 3
Func. diagram: 8050, 8060
Unit selection: -
Expert list: 1
Factory setting
-
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0
FP
8065
8060
-
593