Siemens G130 List Manual page 571

Dependency: Refer to: p2257, p2258, p2267, p2268, p2280, p2285
Note: For bit 00 = 0:
The ramp-down time (p2258) switches to the ramp-up time (p2257) when the sign for the output signal r2260
changes. When the sign changes, the output signal is kept at zero for one arithmetic cycle.
For bit 00 = 1:
When r2260 exhibits a positive gradient, the ramp-up time (p2257) is active; when it exhibits a negative gradient, the
ramp-down time (p2258) is active. The sign for r2260 does not have any effect on the ramp time.
For bit 01 = 0:
The integration time of the PID controller is evaluated with the gain factor Kp (p2280) (p2285 = integral time).
For bit 01 = 1:
The integration time of the PID controller is independent of the gain factor (p2285 = integration time) if p2280 > 0.
For bit 02 = 0:
When the PID controller is deactivated via p2200, the output signal r2294 is reduced to zero via the ramp-down time
p2293.
For bit 02 = 1:
When the PID controller is deactivated via p2200, the output signal r2294 is set directly to zero.
For bit 03 = 0:
The actual values are not limited by p2267 and p2268.
For bit 03 = 1:
The actual values are limited by p2267 and p2268.
p2253[0...n] CI: Technology controller setpoint 1 / Tec_ctrl setp 1
VECTOR_G Can be changed: U, T
(Tech_ctrl)
Data type: Unsigned32 / FloatingPoint32
P-Group: Technology
Not for motor type: -
Min
-
Description: Sets the signal source for the setpoint 1 of the technology controller.
Dependency: Refer to: p2254, p2255
p2254[0...n] CI: Technology controller setpoint 2 / Tec_ctrl setp 2
VECTOR_G Can be changed: U, T
(Tech_ctrl)
Data type: Unsigned32 / FloatingPoint32
P-Group: Technology
Not for motor type: -
Min
-
Description: Sets the signal source for the setpoint 2 of the technology controller.
Dependency: Refer to: p2253, p2256
p2255 Technology controller setpoint 1 scaling / Tec_ctrl set1 scal
VECTOR_G Can be changed: U, T
(Tech_ctrl)
Data type: FloatingPoint32
P-Group: Technology
Not for motor type: -
Min
0.00 [%]
Description: Sets the scaling for the setpoint 1 of the technology controller.
Dependency: Refer to: p2253
SINAMICS G130/G150
List Manual (LH2), 07/2016, A5E03263479A
Calculated: -
Dyn. index: CDS, p0170
Unit group: -
Scaling: PERCENT
Max
-
Calculated: -
Dyn. index: CDS, p0170
Unit group: -
Scaling: PERCENT
Max
-
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
100.00 [%]
2 Parameters
2.2 List of parameters
Access level: 2
Func. diagram: 7958
Unit selection: -
Expert list: 1
Factory setting
0
Access level: 3
Func. diagram: 7958
Unit selection: -
Expert list: 1
Factory setting
0
Access level: 3
Func. diagram: 7958
Unit selection: -
Expert list: 1
Factory setting
100.00 [%]
571