Siemens G130 List Manual page 638

2 Parameters
2.2 List of parameters
p3981 Acknowledge drive object faults / Ackn DO faults
All objects Can be changed: U, T
Data type: Unsigned8
P-Group: Messages
Not for motor type: -
Min
0
Description: Setting to acknowledge all active faults of a drive object.
Notice: Safety messages cannot be acknowledged using this parameter.
Note: Parameter should be set from 0 to 1 to acknowledge.
After acknowledgment, the parameter is automatically reset to 0.
p3985 Master control mode selection / PcCtrl mode select
VECTOR_G, B_INF Can be changed: U, T
Data type: Integer16
P-Group: Setpoints
Not for motor type: -
Min
0
Description: Sets the mode to change over the master control / LOCAL mode.
Value: 0:
1:
Danger: When changing the master control in operation, the drive can manifest undesirable behavior - e.g. it can accelerate
up to another setpoint.
r3986 Number of parameters / Param count
All objects Can be changed: -
Data type: Unsigned16
P-Group: -
Not for motor type: -
Min
-
Description: Displays the number of parameters for this drive unit.
The number comprises the device-specific and the drive-specific parameters.
Dependency: Refer to: r0980, r0981, r0989
r3988[0...1] Boot state / Boot_state
CU_G130_PN, Can be changed: -
CU_G150_PN,
Data type: Integer16
CU_G130_DP,
P-Group: -
CU_G150_DP
Not for motor type: -
Min
0
Description: Index 0:
Displays the boot state.
Index 1:
Displays the partial boot state
Value: 0:
1:
10:
20:
30:
40:
638
Change master control for STW1.0 = 0
Change master control in operation
Not active
Fatal fault
Fault
Reset all parameters
Drive object modified
Download using commissioning software
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
1
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
1
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
-
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
10800
List Manual (LH2), 07/2016, A5E03263479A
Access level: 2
Func. diagram: 8060
Unit selection: -
Expert list: 1
Factory setting
0
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
SINAMICS G130/G150