Completing The Digitizer Installation; Performing A Backup - AGFA CR 30-X Service Manual

DD+DIS150.06E
7

Completing the Digitizer Installation

The purpose of this section is to show the tasks that are required to prepare the
digitizer for hand-over to the Clinical Application Specialist.
The following table lists these tasks.
Task
Perform a backup.
Hand-over the system to
the Clinical Application
Specialist.
*Complete required time per Task Code to be entered in the Agfa repair report.
7.1

Performing a Backup

(1) In the CR 30-X service client select the menu <Backup & Restore>.
(2) Keep the default settings as shown in Figure 24.
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 5
11-2009
Controls, Connections, and Setup Procedures
Required Importance
Time
5 minutes mandatory
5 minutes mandatory
Figure 24
DOCUMENT CONTROL NOTE:
CR 30-X
Type 5175 / 100/110
Task Code* Section
INS
INS
Chapter 1 / 22
Agfa Company Confidential
7.1
7.2