AGFA CR 30-X Service Manual page 217

DD+DIS150.06E
(5) Remove 3 upper screws.
(6) Open 3 lower screws at front cover a few
turns.
(7) Press both handles and pull out front cover
approx. 5 cm.
(8) Disconnect cable at user interface board.
See Figure 186.
(9) Disconnect ground cable at left hand side.
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 2
03-2009
Replacements / Repair Procedures
DOCUMENT CONTROL NOTE:
CR 30-X
Type 5175 / 100/110
Repair and Service
Figure 184
5175R3-5_004.cdr
Figure 185
Figure 186
Figure 187
Chapter 3.5 / 75
Agfa Company Confidential