AGFA CR 30-X Service Manual page 359

DD+DIS147.08E
1 Introduction of Software Patch CRE_1206C
Reason
Product(s) &
Serial
Number(s)
Part
Number(s)
Referenced
Document(s)
2 Introduction of Software Patch CRE_1206D
Reason
Product(s) &
Serial
Number(s)
Part
Number(s)
Referenced
Document(s)
3 Added Post Scan Brush
Reason
Product(s) &
Serial
Number(s)
Part
Number(s)
Referenced
Document(s)
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 0
05-2008
Manufacturing Standard Modifications
To prevent too high displayed LgM-Values.
Digitizer type 5175/100:
Not available via spare part channel, only via GSO library.
Service Bulletin # 05, DD+DIS001.07E
To prevent interfering noise in the image.
Digitizer type 5175/100:
Not available via spare part channel, only via GSO library.
Service Bulletin # 06, DD+DIS027.07E
Improvement of ESD (electrostatic discharge) behaviour of the
digitiser when the image plate is in the post scan area.
Digitizer type 5175/100:
Postscan ESD Brush Kit: CM+ 9 5175 9080 0
Service Bulletin # 08, DD+DIS397.06E
DOCUMENT CONTROL NOTE:
CR 30-X
Type 5175 /100/110
SN ≥ 1170 plus 1089, 1125, 1140,
1148, 1153, 1158, 1162, 1163, 1164,
1165, 1166, 1167, 1168,
SN ≥ 1366 plus 1187, 1260, 1261,
1263, 1338, 1355, 1357, 1363,
SN ≥ 1048 plus 1035, 1039, 1041,
1042, 1043, 1044, 1045, 1046,
Agfa Company Confidential
Chapter 8 / 5