DD+DIS150.06E
4.3
Switching the Digitizer on
(1)
Switch on the control PC.
(2)
Switch on the digitizer.
NOTE:
After switch on a selftest is executed.
If the NX workstation is operational it
takes approximately 1 minute until the
status indicator at the front panel
changes from red to green.
If the NX workstation is not yet
switched on or installed, the status
indicator will stay red flashing.
See Table 1 for meaning of the status
indicator colors.
Status Indicator
Blue - Constant
Green - Constant
Green - Flashing
Red - Constant
Red - Flashing
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 5
11-2009
Controls, Connections, and Setup Procedures
Digitizer Status
Erasure cycle active
Ready
Scan cycle active
Service mode
Boot-Up
No connection to
control PC
Error
Table 1: Description of Status Indicator
DOCUMENT CONTROL NOTE:
CR 30-X
Type 5175 / 100/110
Figure 8: On-off Switch
blue
green or
red
Status indicator
517501ah.cdr
Figure 9
Allowed user action
Wait.
Insert next cassette for
scanning.
Wait.
Check control PC for further
instructions.
Agfa Company Confidential
Erase button
Chapter 1 / 11