Remote Desktop - AGFA CR 30-X Service Manual

DD+DIS150.06E
3

Remote Desktop

Remote connection via the control PC to the digitizer.
Purpose
(1) Connect the service PC to the network where the control PC with digitizer is
Usage
located (e.g. via Agfa SRSS).
(2) On the local PC select 'Start – Programs – Accessories – Communications –
Remote Desktop'.
(3) Enter the hostname or IP address of the processing station.
(4) Select "Connect".
On the processing station start the CR30-X service client.
(5)
NOTE:

The processing station is by default enabled for 'remote desktop'. Enabling for
remote desktop is done via function 'START – Control Panel – System –
Remote".

If the CR30-X service client is started in a remote session, following functions
are not accessible, as they require presence of a service engineer at the
digitizer:
o Diagnose Cycle
o Endurance run cycle
o Calibration (= Shading Calibration)
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 2
03-2010
Figure 26: Example "Remote Desktop Connection" screen
DOCUMENT CONTROL NOTE:
CR 30-X
Type 5175 / 100/110
Repair and Service
Tools and auxiliary Means
Agfa Company Confidential
Chapter 3.2 / 34