Replacing The Roller Clamping Stepper Motor (M6) - AGFA CR 30-X Service Manual

DD+DIS150.06E
2.19

Replacing the Roller Clamping Stepper Motor (M6)

REQUIRED SPARE PART*:
CM+9 5175 8680 0
* The last digit in the spare part number indicates the spare
part revision at release of this document. When ordering,
the actual revision of the spare part is delivered.
REQUIRED TOOLS:
REQUIRED TIME:
30 min.
DISASSEMBLY:
(1) Switch off the digitizer.
(2) Disconnect the mains cable.
(3) Simultaneously press the two buttons (A)
positioned underneath the feed table.
(4) Pull out cassette unit (B).
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 2
03-2009
3 mm,
with ball-shaped head
DOCUMENT CONTROL NOTE:
CR 30-X
Type 5175 / 100/110
Repair and Service
Replacements / Repair Procedures
Figure 141
B
A
Figure 142
Agfa Company Confidential
A
Chapter 3.5 / 59